How to use presets?

If you want a quick start with Kheper3 you can use our prests settings that cover most standard scooter models.

Note that you will have to change your stator position to the indicated position, if you are not familiar with this procedure I encourage you to look at this websites: scoterhelp

You will select the curve with the select wheel on the kheper3, no need of a computer, just use a smal flat screwdriver to position the arrow on the preset:

 

 

Wheel position Stator position (DEGREES) FUNCTIONS
0 RECOVER MODE – LIKE A NORMAL CDI = NO DELAY
1 CUSTOM CURVE 1 learn more here
2 CUSTOM CURVE 2 learn more here
3 CUSTOM CURVE 3 learn more here
4 24 PX125
5 26 PX200
6 24 PK-ET3
7 26 V TRONIC
8 26 LAMBRET
9 26 MOD
A 28 RACE1
B 28 RACE2
C 28 RACE3
D 28 RACE4
E 28 RACE5
F USB MODE : USED FOR USB LOADINGAND FIRMWARE UPDATE

 

Below are the presets in x axis is the motor RPM, and Y represents the delay in degrees:

 

One thought on “How to use presets?

  • hello, the stator degree is BTDC or ATDC? im trying to get this cdi to work on my zuma bws engine. you have any tips? im not sure where i need to set the baseline timing.

Leave a Reply to Jarib McCann Cancel reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload the CAPTCHA.